Fort Lauderdale Gate Pros provides professional driveway gates in Fort Lauderdale, FL for residential and commercial properties across Broward County. Driveway gates change how a Fort Lauderdale property reads from the street more than any other single thing you can add to it, and choosing one is mostly a question of what the site will physically allow rather than which photograph you liked. Before anybody talks about scrollwork we measure four things: the clear opening width, the driveway depth from the sidewalk to where a car actually stops, the slope both across and along the drive, and what electrical power exists anywhere near the street. Those four numbers eliminate most of the catalogue before you have spent a dollar, and it is far cheaper to discover that on paper than after fabrication. Geometry decides the mechanism. A swing leaf sweeps an arc equal to its own width, so a twelve-foot leaf needs twelve feet of clear, level ground to travel through, and an out-swing gate that ends up over a public sidewalk is a gate that will not pass inspection. On the deeper lots inland there is usually room for a proper dual swing, which we prefer over one wide leaf because two leaves halve the arc, halve the hinge load and halve the wind area each leaf has to carry. On the narrow waterfront and canal lots, where the house sits close to the street and a seawall setback eats the rest, a slide or bi-fold configuration is frequently the only thing that physically works. Exposure decides the material, and this is where Fort Lauderdale differs from almost everywhere else we could be working. Airborne salt carries several miles inland on the prevailing easterly, so on any property near the beach, the Intracoastal or a canal we specify marine-grade aluminum with stainless fasteners, or hot-dip galvanized steel under the powder coat where the client wants the mass of iron. Untreated steel here rusts from inside the tube where nobody can see it, and by the time a blister shows on the coating the wall is already compromised. Width is the other thing people get wrong. Ten feet looks generous on a drawing and is tight in practice, twelve is comfortable for a single lane and sixteen for two, and in a boating city you should measure the trailer rather than the car. Automation gets planned now rather than bolted on later: conduit for the operator, exit loop, keypad and intercom is cheap before the driveway is poured and expensive afterward. Every gate is fabricated to your opening in our own shop, welded square, finished inside and out, and hung on posts set deep in concrete sized for hurricane-zone wind load.
With 15+ years of experience, our licensed and insured team brings the right materials and equipment to every job — wrought iron and ornamental steel fabrication, marine-grade powder-coated aluminum, cantilever and roller slide gates, LiftMaster, DoorKing and FAAC operators, Class I-IV operator classifications, UL 325 entrapment protection — and backs the work with a written workmanship warranty. We serve Fort Lauderdale and nearby communities including Pompano Beach, Oakland Park, Wilton Manors, Lauderdale-by-the-Sea.
What We Handle
Everything our driveway gates in Fort Lauderdale covers
One crew, one point of contact, and the full range of driveway gates work in Fort Lauderdale, FL. If it is on this list we do it in house rather than handing it to a subcontractor:
- driveway gates Fort Lauderdale
- gates for the driveway
- automatic driveway gates
- electric driveway gates
- motorized driveway gates
- metal driveway gates
- double driveway gates
- driveway gate designs
- driveway gate ideas
- driveway gate cost
- heavy duty driveway gate hinges
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Fort Lauderdale services.
Materials, equipment and how we do driveway gates
The difference between driveway gates that lasts and driveway gates that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with wrought iron and ornamental steel fabrication, marine-grade powder-coated aluminum, cantilever and roller slide gates, LiftMaster, DoorKing and FAAC operators, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Fort Lauderdale job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. 15+ years of gate work in Broward County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do driveway gates outside Fort Lauderdale
Fort Lauderdale Gate Pros covers Fort Lauderdale and the surrounding communities of Broward County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Driveway Gates in Pompano Beach, FL — Broward County, incorporated as the Town of Pompano on July 3, 1908, population 112,046 at the 2020 census
- Driveway Gates in Oakland Park, FL — Broward County, incorporated as Floranada on November 25, 1925, population 44,229 at the 2020 census
- Driveway Gates in Wilton Manors, FL — Broward County, incorporated as a village on May 13, 1947, population 11,426 at the 2020 census
- Driveway Gates in Lauderdale-by-the-Sea, FL — Broward County, incorporated November 30, 1927, population 6,198 at the 2020 census
- Driveway Gates in Lighthouse Point, FL — Broward County, incorporated as a town on June 13, 1956, population 10,486 at the 2020 census
- Driveway Gates in Deerfield Beach, FL — Broward County, incorporated as a town on May 12, 1939, population 86,859 at the 2020 census
Start on the Fort Lauderdale Gate Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Fort Lauderdale Chooses Fort Lauderdale Gate Pros
- ✓Over 15 years installing and automating gates across Broward County
- ✓In-house metal shop — we weld and powder coat our own gates rather than drop-shipping them
- ✓Marine-grade aluminum and hot-dip galvanized steel specified for coastal salt air
- ✓Waterfront, canal-front and marina-community gate work is a specialty, not a sideline
Every driveway gates project in Fort Lauderdale gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free driveway gates free estimate in Fort Lauderdale, or request a quote and we'll get right back to you.